Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - smatt241

Pages: [1]
Zodiac FX General / Adding Meter Entries/QoS
« on: August 23, 2016, 09:41:59 PM »
Hi all,

Are meter entries (OpenFlow 1.3) supported with the Zodiac (v. 0.64) as I cannot seen to get them working with the switch (using the Ryu controller).

I have tried to add a simple meter entry using the following REST call:

curl -X POST -d '{
    "flags": "KBPS",
    "meter_id": 1,
    "bands": [
            "type": "DROP",
            "rate": 1000
}' http://localhost:8080/stats/meterentry/add

which returns "OK 200".

I then go to verify the entry registration with:

curl -X GET http://localhost:8080/stats/meterconfig/XXXXXXXXXXXXXX

which does not return the meter entry previously added.

Any help would be appreciated!


Zodiac FX General / Re: connecting hosts (PCs, rPis) to Zodiac
« on: August 23, 2016, 08:51:53 PM »
Thanks Paul! :)

Zodiac FX General / connecting hosts (PCs, rPis) to Zodiac
« on: July 24, 2016, 10:16:43 PM »
Hi all

I am trying to connect two hosts to ports 1 & 2 of the Zodiac FX with port 4 connected to my home gateway (port 3 is unused).

I am having trouble connecting the hosts to the network as when I connect them to the Zodiac ports 1 & 2, no IP address is given to each host. Even when using "dhclient" on the ethernet interface of each port or setting each host with a static IP, I still cannot seem to connect the hosts to the network.

Is there a step I am missing when trying to create a network with your home gateway and two host PCs to test OpenFlow with real traffic?

Kind Regards

Pages: [1]