Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - balahmadi

Pages: [1]
1
Hi Sebastian

I am also creating a testbed with 5 Zodiac FX and one RPi with OpenVswitch.
 I want to configure my testbed so that the network has multiple subnets (specifically a fat tree topology).
However, when configuring the IPs of the switches, the controller was not able to see them.
Did you configure all your 12 Zodiac switches to beon the same subnet? Do you have any suggestions for subnetting using Zodiac FX?

Many thanks!

2
Zodiac FX General / Zodiac FX with multiple subnets
« on: December 18, 2018, 10:36:34 PM »
Hello

I am an SDN newbie, and I want to create a testbed with 5 Zodiac FX and one RPi with OpenVswitch.
 I want to configure my testbed so that the network has multiple subnets (specifically a fat tree topology).
However, when configuring the IPs of the switches, the controller was not able to see them.
My question is:
- Does the Zodiac FX switch need to be on the same subnet as the Controller?
- Is subnetting using Zodiac FX possible or does it need to be written as an application?
I am attaching a picture of the desired topology.
Any advice is really appreciated!
Thank you!

Pages: [1]