Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - Kent-H

Pages: [1]
Zodiac FX General / FX Refusing to Stay Connected
« on: August 31, 2018, 01:16:00 AM »
I just got a few FX switches, but they refuse to stay connected to my controller (I'm going to be using them to test this custom controller.)

Hello requests are given a hello response, and echo requests are given an echo response.  (I know these are normally required to avoid disconnecting).

Most of the time, I don't even see an echo request, just a hello (which I immediately respond to).  Then, anywhere from 0.5 - 2 seconds later, the connection is dropped and a new one is attempted.

Does the FX have more stringent requirements than this (hello & echo responses) for staying connected?  Do I need to send echo requests or something?

Zodiac FX General / Request: Write & Match on Metadata
« on: June 14, 2018, 05:45:07 AM »
I have a project that requires multiple tables w/ metadata support, so I'm trying to locate a (relatively inexpensive) switch that supports both. 

Multiple tables (10, I believe?) are supported by the FX, but it appears that Metadata currently is not.

Would it be possible to support writing/matching on metadata? 

Pages: [1]