Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - nexusnet

Pages: [1]
1
I am unable to backspace to correct typos in the CLI unless I use the Mac Command key + delete. Even then, the cursor moves back but does not "clear" the errant character(s). It's a keyboard mapping issue, probably; but I do not have any problem in Linux shells from the same Mac. So I'm puzzled that I'd experience the only on the FXs. Any thoughts?

Tx,

Robert

2
Zodiac FX General / Only one of my units responds to ping
« on: July 11, 2016, 01:09:17 PM »
I have several FX attached to my core switch. They have IP 10.0.1.99 down to 95. I am able to ping 99, but not any of the others. I confirmed ip, mask, gateway were correct in config on each. Saved the config after changing ip. Checked that I have live connections to port 4 on each unit. Confirmed that port 4 state is UP on each unit. I also tested on a completely different, stand-alone switch - same results. Has anyone else experienced issues after changing the ip of their FX switch? Probably I'm missing something obvious and simple.

Tx,
Robert

3
Zodiac FX General / Sample configuration for network switch
« on: June 09, 2016, 10:54:24 PM »
I have just started to learn openflow - got connected to my FX last night. Through my initial fumbling, I realized that a sample configuration that makes the FX act like a standard LAN switch would be helpful as a starting point. I learn faster if I start with something that works, then specialize / adapt from that baseline. If anyone could post such, I'd appreciate.

Best,
Robert

Pages: [1]